Technical Parameter
| Item | Unit | TCVR-170A | ||
| Dia.of table | mm | Φ170 | ||
| Dia.of center hole of table | mm | Φ50 | ||
| Inner hole dia. Of center sleeve | mm | Φ40 | ||
| Center through hole dia. | mm | Φ40 | ||
| Height of table(Horizontal) | mm | 245 | ||
| Width of T-slot of table | mm | 12H7 | ||
| Width of location key | mm | 18h7 | ||
| Specification of Axis | Rotary axis | Tiling axis（±100°） | ||
| Minimum setting unit | deg | 0.001 | 0.001 | |
| Dividing accuracy | sec | 25 | 60 | |
| Repeat positioning accuracy | sec | 8 | 8 | |
| Clamp system(by qneumatic) | Kg/cm² | -6 | -6 | |
| Clamp torque | kgf.m | 20 | 20/28 | |
| Servo motor | FANUC | Optical axis | α4i/β4is | α4i/β8is |
| Siemens | Optical axis | 1FK7042 | 1FK7042 | |
| Reduction ratio | - | 1/72 | 1:/120 | |
| Max.speed（FANUC α） | rpm | 33.3 | 25 | |
| Total weight(without motor) | kg | 130 | ||
| Permissible load inertia capacity | Kg.cm.sec² | 4.13 | ||
| Permissible workpiece load | Horizontal | kg | 75 | |
| Tiling | kg | 50 | ||
| Permissible Load（Clamp） | Horizontal | kgf | 750 | |
| Tiling | kgf.m | 28 | ||
| Permissible cutting torque | kg.m | 18 | ||
